Free Expert Guides on Power Systems, Circuit Design & Electrical Troubleshooting

1. Power Interruption Problems Caused by RCD False Tripping During Lightning StrikesA typical communication power supply circuit is shown in Figure 1. A residual current device (RCD) is installed at the power supply input terminal. The RCD primarily provides protection against electrical equipment leakage currents to ensure personal safety, while surge protective devices (SPDs) are installed on power supply branches to protect against lightning intrusions. When lightning strikes occur, the senso

High-voltage disconnectors are extremely widely used, and therefore people pay great attention to potential problems that may arise with them. Among various faults, corrosion of high-voltage disconnectors is a major concern. In light of this situation, this article analyzes the composition of high-voltage disconnectors, types of corrosion, and faults caused by corrosion. It also investigates the causes of disconnector corrosion and studies theoretical foundations and practical techniques for cor

Common Issues and Solutions for SPDs in Practical ApplicationsSurge Protective Devices (SPDs) are critical for protecting electrical systems from transient overvoltages. However, several common issues occur in real-world installations: Insufficient maximum continuous operating voltage (Uc): Uc is lower than the grid’s maximum possible voltage, leading to SPD overheating or failure. Voltage protection level (Up) exceeds equipment impulse withstand voltage (Uw): SPD cannot adequately protect sensi

Example of electrical insulation diagram

10KV Switchgear relay protection circuit

A circuit that prevents the switch from jumping

Motor Thermal Overload Protection

Generator differential protection

Small and Large Motor Protection Scheme

Backup O/C & E/F Protection Scheme